To seal the gap between a kegerator and a countertop, you can follow a simple and effective method using PVC pipe and pipe insulation. This technique not only helps to close the gap but also provides insulation to prevent any air leakage or temperature loss.
Here's a step-by-step guide on how to seal the gap:
1. Measure the gap: Start by measuring the width and depth of the gap between your kegerator and countertop. This will help determine the length of PVC pipe and pipe insulation you'll need.
2. Get the materials: Visit a local hardware store and purchase a small length of PVC pipe (around 6-10 inches) with a diameter that matches the width of the gap. Additionally, look for pipe insulation typically used around copper pipes.
3. Cut the PVC pipe: Using a saw or a pipe cutter, cut the PVC pipe to fit the depth of the gap. Ensure that the pipe is cut precisely to avoid any gaps or unevenness.
4. Install the PVC pipe: Place the cut PVC pipe into the gap between the kegerator and countertop. The pipe should fit snugly to fill the space.
5. Apply pipe insulation: Take the pipe insulation and wrap it around the PVC pipe, covering the entire length. Make sure the insulation is tight and secure to provide effective sealing.
6. Secure the insulation: You can use tape or adhesive to secure the pipe insulation in place. This will prevent it from slipping or moving over time.
7. Test for effectiveness: Once the PVC pipe and insulation are installed, check for any gaps or openings. Run your hand along the sealed area to ensure it's properly sealed and there's no air leakage.
By following these steps, you can effectively seal the gap between your kegerator and countertop, preventing air leakage and maintaining the desired temperature inside the kegerator.
Personal experience: I recently had to seal the gap between my kegerator and countertop in my home bar. I initially noticed a slight draft and temperature fluctuation, which affected the quality and taste of the beer. After some research, I came across this PVC pipe and insulation method, which turned out to be a simple yet effective solution. I followed the steps mentioned above and was pleased with the results. The gap was completely sealed, and I no longer experienced any air leakage or temperature loss. The beer quality improved significantly, and I could enjoy my favorite brews without any issues.